Instructions for J’adore Adorn Bluetooth Headset setup

 

Thank you for choosing your J’adore Adorn Headset.

 

These step-by-step instructions will enable you to pair your Bluetooth Ready Luxury Handmade Swarovski Crystal Headset with your device.

 

We hope you enjoy using your headset and please contact us if you need any further assistance.


 

Bluetooth Pairing
 

  1. Ensure your headset is switched off and then hold the “Play” button down for seven seconds continuously until the you see the red and blue flashing light.

  2. On your mobile device, open the Bluetooth function (at scan mode) and detect name “BT”. This is your J’adore Adorn headset.

  3. Select the headset from scanned list and wait for the items to pair. Please note that some mobile devices require a password, at which point you should enter “0000”.

 

Bluetooth Controls
 

  1. To turn your Bluetooth headset on

    1. At power off status, hold the “Play” button down for three seconds continuously until you see a blue flashing light. This indicates that Bluetooth is on.

    2. Turn on Bluetooth on your mobile device and select the headset name “BT” from the Bluetooth list.

    3. The mobile device and headset will then connect.
       

  2. To turn your Bluetooth headset off

    1. At any status, hold the “Play” button down for three seconds continuously until you see a red flashing light. This indicates that Bluetooth is off.
       

  3. To increase volume

    1. Press “+” button once.
       

  4. To decrease volume

    1. Press “-” button once.
       

  5. To listen to next song

    1. Press “+” button for two to three seconds continuously.
       

  6. To reserve a song

    1. Press “+” button for two to three seconds continuously.

 

  1. To pause music

    1. Press “Play” button once. To resume music, press “Play” button once again.
       

  2. To answer a phone call

    1. When a call is incoming whilst you are playing music you will hear a signal. Press “Play” button to answer the phone call. Press “Play” button again to end the call.

 

  1. To activate Siri function (iPhone only)

    1. Press “Play” button for two seconds continuously to activate “Siri” function.